A fence can need up to 3 approvals before the first post hole: a city or county permit, an HOA approval and a utility locate. They come from 3 different places, and none of them replaces the others.
This guide covers the rules in 12 jurisdictions and the HRCA where Regal Fencing works, from Denver and Lakewood south to Castle Rock and Elizabeth. Each rule below comes from the city, county or HOA document named with it, checked in November 2026.
Codes change, and a few limits are still being confirmed with the cities. Where we couldn't confirm a number, we left it out. Treat this page as a starting point and check with your city before you build.
Which cities require a permit for every new fence?
Centennial, Littleton and unincorporated Arapahoe County all require a permit for every new fence, whatever its height. Littleton also asks for stamped engineering on a fence over 7 ft. Lakewood requires a permit too, unless the fence is under 8 ft long and under 6 ft high.
Which cities require a permit only above a set height?
Aurora requires a permit only for a fence above 7 ft, according to the city's DIY Home Improvement Handbook. Parker, the Town of Elizabeth and unincorporated Douglas County, which includes Franktown, set the line at over 6 ft. Lone Tree and Castle Pines set it at over 7 ft, and Lone Tree requires a permit at any height inside its wildfire interface district.

Do you need a fence permit in Denver?
Yes, for most backyard fences. Denver requires a zoning permit for a fence over 4 ft and a building permit for a post-hole fence over 8 ft. Our Denver fence permit guide covers the height and setback rules in full.
How tall can a backyard fence be?
The side and rear limit is 6 ft in Denver, Littleton, Lakewood, Lone Tree, Elizabeth and unincorporated Arapahoe County. Castle Rock's municipal code sets 72 inches, which is the same height. Centennial is the exception at 8 ft.
How tall can a front yard fence be?
Front yards are held lower. Denver and Centennial allow 4 ft, as do Lone Tree inside front setbacks and Elizabeth in the front yard. Castle Rock sets 48 inches inside the front setback, and unincorporated Arapahoe County allows 3 ft in front of the building.
Does a front yard fence have to be see-through?
In 2 of these cities, yes. Littleton allows 48 inches in front and requires the fence to be at least 50 percent open, rising to 75 percent on corner lots. Lakewood allows 4 ft and also requires at least 50 percent open.
How far from the sidewalk does a fence have to sit?
Denver and Centennial both require 6 inches back from the sidewalk, and Centennial requires 5 ft from the street where there is no sidewalk. Littleton requires 2 ft from sidewalks and the right-of-way, and Lakewood requires posts 2 ft behind the sidewalk. Unincorporated Arapahoe County sets a 16 ft sight triangle and an 8 ft corner setback, and Douglas County never allows a fence in the public right-of-way or where it blocks a driver's view.
Which fence materials do cities restrict?
Chain link and wire draw the most rules. Centennial allows chain link only in interior side and rear yards and bans barbed wire on homes, and Lone Tree bans chain link on homes along with electric, concertina and razor wire. Lakewood allows barbed wire only on R-L-A lots of 1 acre or more, and unincorporated Arapahoe County bans barbed and electric wire outside agricultural and industrial zones.
What does unincorporated Douglas County allow?
Douglas County's Zoning Resolution is the looser code on wire, which suits acreage around Franktown. Barbed wire is allowed, electric wire is allowed if it is posted, and concertina and razor wire are banned. The county requires a permit only for a fence over 6 ft.
Is HOA approval the same as a fence permit?
No. A permit comes from your city or county and applies its zoning and building codes. HOA approval comes from your association and applies its covenants, so you can need one, both or neither.
How does the HOA fencing approval process work?
You apply before any work starts, and you wait for a written answer. The Highlands Ranch Community Association is a good model of what an HOA asks for: a site plan with the fence location marked, the style and height of the fence and gates, and the stain color. Your own HOA's list may differ, so read its design guidelines first.
How long does HOA approval take?
It varies by association, so check your covenants for the review period. In Highlands Ranch, the HRCA's committee must act within 30 days of receiving a complete submittal. Book your estimate early enough that the review fits ahead of your build date.
What do HOA fence rules usually cover?
Height, material, color, gate size and which side faces out. The HRCA, for example, requires solid fences to be 5 or 6 ft of rough-sawn cedar with a top cap, and it prohibits plastic and vinyl fencing. Our Highlands Ranch guide lists those rules in full.
What does Colorado 811 require before you dig?
Colorado law requires notice to 811 at least 2 business days before digging, not counting the day you call, under C.R.S. 9-1.5-103. Colorado 811 asks for 3 business days. Regal requests the locate for every install, at least 3 business days before we dig.
How do you find your property line?
Start with the site plan or plat from your home purchase, and look for survey pins at the lot corners. A fence estimate is not a survey. If the line is unclear or disputed, hire a professional land surveyor before the fence goes up.
How deep do fence posts need to go?
Regal sets fence posts 24 to 36 inches deep. Boulder and Longmont publish a 24 inch minimum. Frost depth is 36 inches under Aurora's Engineering Design Criteria and Douglas County's 2021 code amendments, a figure written for footings and foundations. Ask what footing depth is in your written quote.
What does Regal Fencing handle for you?
Jackson Vann checks your city's rules at the free on-site estimate and gives you the fence details an HOA submittal needs. Regal offers permit guidance, helps you get HOA approval and requests the 811 locate. Any sprinkler line we damage during the install is fixed for free.
Looking for fence designs that HOAs approve?
This page covers rules and process. For styles and looks, read our blog post on HOA approved fence ideas. Then bring your HOA's guidelines to the estimate and we'll match a design to them.

